Question: pcmtuner account has expired. I can not open pcmtuner application for connection diagrams. it’s possible to reactivate/renew it?   Solution: Just contact tuner-box.com with your email and serial number. Or contact contact tuner-box via WhatsApp +1 (802) 884-0961.

Here comes the unbiased review of foxflash ecu programmer on June 1st, 2023.   Credit to sazimam.   “Because the FoxFlash is working very good for me.  I decided to make this review of facts and tested procedures. It works only in ONLINE mode. You won’t run the software without it. It works only with the device connected to USB port, like the others....

Foxflash ecu programmer released new update-adding Bench/Boot protocol for Isuzu EDC17C83. May 23, 2023 update May can’t get any better as we release a new exclusive protocol today! In this update, you’ll find the BENCH protocol for Isuzu EDC17C83. Supported Control Units & Vehicles ECU: Bosch EDC17C83 TC1793   Supported Vehicles:   Isuzu Dmax 2017-2022...

Some users reported they try to download foxflash software to a new computer but showed this message: Error “Execute Download with DFBTech_UPDATER for Tool” Solution: Make sure 1. Defender off. (*We found part of them did not turn off real-time scanning windows. This also causes the error to occur.) 2. Date/time sync off  ( Open manager and click Active. CHECK...

Real test feedback and reviews of Foxflash ECU/TCU tuning tool.   Success: EDC17Cp39 on Freelander 2 obd read write chk okMD1CP001 MB W213 2018y R/W OK , checksum calculated from the original file.Dcm6.2c – r/w ok. Full or partial, all ok. It was boot mode just for testing purposesBMW MG1CS003 Read/Write okBmw edc17c06 BENCH, Read ok, Write ok, Checksum ok, car startsAudi A3 2017...

Problem: Can some body help me this pcmtuner issue I can't write this. Error problem preparing selected file.   Possible reason: File is in correct or wrong module selected.  

How to read/write a Delphi DCM3.7AP ecu with foxflash ecu programmer?   Foxflash will read Cheverolet, GM and Opel Delphi DCM3.7AP MPC55xx ecus.   Delphi DCM3.7AP Jtag MPC55xx pinout to Foxflash Delphi DCM3.7AP MPC55xx Solder the rainbow flat cable on the pcb: To read and write use the following driver: ->BDM/Jtag ->BDM/Jtag Mode ->Jtag Nexus MPC/SPC...

Foxflash recent update adds FCA Dodge CONTINENTAL GPEC4 ECU.   Here is the foxflash pinout to CONTINENTAL GPEC4 BAM SPC5674 CONTINENTAL GPEC4 FCA Pinout   Connect with the multifunction cable the CNF1 on the pcb. Read and Write ECU Use the driver:→ TOOLS BOOT MODE→ MOTOROLA FREESCALE BAM→ FCA CONTINENTAL GPEC4

How to read and write FCA Chrysler Jeep Dodge CONTINENTAL GPEC4LM ECU with foxflash? Check foxflash pinout to CONTINENTAL GPEC4LM BAM SPC5674 CONTINENTAL GPEC4LM FCA Pinout   Connect with the multifunction cable the CNF1 on the pcb.   Read and Write ECU Use the driver:→ TOOLS BOOT MODE→ MOTOROLA FREESCALE BAM→ FCA CONTINENTAL GPEC4LM